Configuration Overview - Cisco Prisma II Installation And Operation Manual

Configuration Overview

Overview
The Prisma II Optical Amplifier is shipped from the factory with operational
parameters set to factory defaults. However, you will probably choose to configure
the operating parameters so that they are best suited for your application.
Configuration and Monitoring Methods
The Prisma II Optical Amplifier may be controlled using one of three different
methods.
• Prisma II ICIM
If an ICIM is installed in the Prisma II Chassis, it may be used to configure and
monitor Prisma II application modules within its domain. For instructions on
operating this module using the ICIM, refer to Chapter 3, Operation Using the
ICIM.
• LCI software
The LCI software running on a locally connected PC may be used to configure
operating parameters of Prisma II modules. For instructions on operating this
module using the LCI software, refer to Chapter 4, Operation Using LCI.
• TNCS software
If the ICIM is installed, TNCS software may be used to configure and monitor all
functions of the Prisma II modules. For instructions on operating this module
using TNCS, see the manual that was shipped with the TNCS software.
Configuration Summary
For detailed information on configuring this module, see Chapter 3, Operation
Using the ICIM or Chapter 4, Operation Using LCI.
78-739260-01 Rev F Introduction 1-7