Operating Status Parameters - Cisco Prisma II Installation And Operation Manual

Operating Status Parameters

Introduction
The following table describes the monitored operating parameters for this module.
Parameter Name (LCI)
Laser Input Power
Output Power
Laser Temperature
Laser Bias Current Limit
Laser Bias Current
TEC Current
Module Temperature
Laser On Time
Enable Laser
Optical Power Attenuation
Master
Low Input Alarm Inhibit
Note: Not all parameters pertain to every optical amplifier. However, some optical
amplifiers have multiple lasers and so have multiple laser temperatures, limits, bias,
and so on. Any such multiples are designated in numerical order; for example,
LasTemp1, LasTemp2, LasTemp3; LasLim1, LasLim2, LasLim3; LasBias1, LasBias2,
LasBias3; and so on.
A-2
ICIM
Abbrev.
InPwr Optical input power
OutPwr Optical output power
LasTemp Laser temperature
LasLim Laser operating current limit
LasBias Laser operating current
TecCur Thermoelectric cooler current
ModTemp Module temperature
LaserOn Laser in-service hours
Enable Laser on or off
SetAtten Optical power attenuation
Master Master or Slave operation
LoInpInh Disables low input alarm
Module Parameter Descriptions
Function
78-739260-01 Rev F
Units
dBm
dBm
deg C
A
A
A
deg C
Hrs
ON or
OFF
dB
ON or
OFF
ON or
OFF