Starting Lci - Cisco Prisma II Installation And Operation Manual

Starting LCI

Introduction
When LCI is started, it polls the module(s) located in the chassis to which your
computer is attached. For each module it finds, LCI:
• Represents the module in the module tree of the main LCI window.
• Makes the polling information available so you can check and configure various
parameters.
Important: Your computer must be connected to the chassis before you start LCI.
For instructions, refer to Connecting Your Laptop Computer to the Chassis earlier
in this chapter.

Starting LCI

Follow these steps to start the LCI software.
1. Double-click the LCI icon on your Windows desktop.
Result: The LCI Detect Configuration window appears.
4-8 Operation Using LCI 78-739260-01 Rev F