System Maintenance
Modifying a Configuration File
Method One
Rev 1.02
To optimize your HTRD400 System performance, you may from time to time want to
replace the current HTRD400 Recorder configuration. The subsections that follow
describe the following tasks:
•
Reviewing the recorder date and time settings
•
Modifying recorder settings
•
Modifying trigger inputs
•
Modifying camera settings
•
Reviewing GPS configuration
•
Modifying record rule settings
•
Adding, editing, or removing user accounts
•
Erasing the recorder hard drive
•
Upgrading the firmware on the recorder and camera(s)
When you connect to the recorder, a summary of the configuration settings displays on
the Configuration tab.
Note
Most modifications require that you are connected to the recorder. For a
complete list of these tasks, see
There are three ways to modify an existing configuration file:
•
Using the HTRD400 System Setup Wizard
•
Modifying individual components from the Task Overview tab or from the Configure
menu
•
Modifying individual components from the Configuration tab
Use the HTRD400 System Setup Wizard
1.
On the Task Overview tab, click Start Wizard .... The HTRD400 System Setup
Wizard starts.
Table 5-1
on
73
6
page
36.
Document 900.0328
05/05