Cisco SPA301 Administration Manual page 329

Cisco SPA IP Phone Field Reference
Ext Tab
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
Refer Target Bye
Delay
Sticky 183
Auth INVITE
Ntfy Refer On 1xx-
To-Inv
Use Anonymous
With RPID
Set G729annexb
Description
For the Refer Target Bye Delay, enter the appropriate
period of time in seconds.
Defaults to 0.
If this feature is enabled, the IP telephony ignores further
180 SIP responses after receiving the first 183 SIP
response for an outbound INVITE. To enable this feature,
select yes. Otherwise, select no.
Defaults to no.
When enabled, authorization is required for initial incoming
INVITE requests from the SIP proxy.
If set to yes, as a transferee, the phone will send a NOTIFY
with Event:Refer to the transferor for any 1xx response
returned by the transfer target, on the transfer call leg.
If set to no, the phone will only send a NOTIFY for final
responses (200 and higher).
NOTE Not applicable to the
This parameter applies only if <SIP Remote-Party-ID> is
set to yes; otherwise, it is ignored.
If the parameter is set to yes, the FROM header's display-
name and user-id fields are set to anonymous when the
caller blocks his caller-id. If the parameter is set to no, the
FROM header's display-name and user-id are not masked.
The Remote-Party-ID header indicates privacy=full when
the caller wishes to block his caller-id.
Defaults to yes.
NOTE Not applicable to the
Configure G.729 Annex B settings.
NOTE Not applicable to Cisco SPA525G or Cisco SPA525G2.
Cisco WIP310
.
Cisco WIP310
.
A
329