Cisco SPA301 Administration Manual page 184

Provisioning
Updating Profiles and Firmware
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
Upgrade Enable
Upgrade Error Retry
Delay
Downgrade Rev Limit
Upgrade Rule
Log Upgrade Request
Msg
Log Upgrade Success
Msg
Log Upgrade Failure Msg
License Keys
Description
Allows firmware update operations independent of
resync actions. Defaults to yes.
The interval applied in the event of an upgrade
failure. The firmware upgrade error timer activates
after a failed firmware upgrade attempt and is
initialized with this value. The next firmware
upgrade attempt occurs when this timer counts
down to zero. The default is 3600 seconds.
Enforces a lower limit on the acceptable firmware
version number during an upgrade or downgrade.
The device does not complete a firmware upgrade
operation unless the firmware version is greater
than or equal to this parameter. For example:
7.4.8
The default is (empty).
A firmware upgrade script that defines upgrade
conditions and associated firmware URLs. It uses
the same syntax as Profile Rule. (See
Provisioning a Phone from the Keypad
Upgrade Rule syntax.) The default is (empty).
Syslog message issued at the start of a firmware
upgrade attempt. The default is
$PN $MAC -- Requesting upgrade
$SCHEME://$SERVIP:$PORT$PATH
Syslog message issued after a firmware upgrade
attempt completes successfully. The default is
$PN $MAC -- Successful upgrade
$SCHEME://$SERVIP:$PORT$PATH -- $ERR
Syslog message issued after a failed firmware
upgrade attempt. The default is
$PN $MAC -- Upgrade failed: $ERR.
This field is not used.
6
Manually
for the
184