Installation With Surface Mount Bracket - Honeywell 10X User Manual

Installation with Surface Mount Bracket

Remove the ceiling tile from the ceiling and cut a
hole whose diameter is 30-40mm on the ceiling tile
to pass the wires and cables through to the upside
of the ceiling. (In case of wiring and cabling through
the ceiling tile only)
Connect the main cable to the ports and install the
main body. (Machine M3×8)
Important Notice
Before starting the installation, make sure that the camera ID and protocol are set up properly.
When the wiring access hole on the side of the surface mount bracket is not used, make sure that the hole is
properly sealed with the supplied rubber gasket.
Document 800-06705 - Rev A - 12/10
Mini PTZ Dome Camera User Guide
Prepare the surface mount bracket. Pull the main
cable for the system as below. Attach the surface
mount bracket to the mounting surface. (Tapping
M4×25)
Align the dome cover stud with the stud on the main
body and slightly push the dome cover to the
ceiling. Turn the dome cover clockwise and install
the dome cover lock-up screw. Then remove the
protective vinyl from the dome cover. (Machine
M3×6)
19