Group Setup - Honeywell 10X User Manual

Group Setup

GROUP SETUP
------------------------
GROUP NO.
CLEAR GROUP
RUN GROUP
<EDIT GROUP>
BACK
EXIT
Group Edit
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE
CANCEL [NEAR:EDIT]
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [NEAR:EDIT ACT]
CANCEL [FAR :EDIT END]
EDIT GROUP 1
------------------------
NO ACTION ### DWELL OPT
------------------------
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
------------------------
SAVE [ :MOVE CURSOR]
CANCEL [ :CHANGE VAL.]
Document 800-06705 - Rev A - 12/10
Group Number
1
UNDEFINED
CANCEL
Clear Group
Run Group
Edit Group
[1~8]
Selects a Group number to edit.
If the selected Group number is not defined,
UNDEFINED is displayed under the selected Group
number.
[CANCEL/OK]
Deletes the data of the selected Group.
Runs the Group for the test purposes to check if it
works properly.
Edits the selected Group.
Press the Near key when the cursor is at "NO" to start editing the
selected Group.
Note that maximum 20 actions are allowed in a Group. Move the
cursor up/down to select an Action. Press the Near key to edit the
Action.
Define Action, Dwell Time and Option. Move the cursor using the
Left/Right arrow buttons of your controller to select an item. Move the
cursor using the Up/Down arrow buttons on your controller to change
each parameter.
ACTION [NONE/PRESET/SWING/PATTERN]
DWELL [0 SEC. ~ 4 MIN.]
Sets the Dwell Time between functions.
OPT Option. It is the Preset speed when the
selected action is a Preset. It is the number of
repeats when the selected action is a Pattern
or Swing.
Mini PTZ Dome Camera User Guide
43