Preset; Swing - Honeywell 10X User Manual

Preset

Function
Setting Presets
Running Presets
Deleting Presets

Swing

Function
Setting Swings
Running Swings
Deleting Swings
Document 800-06705 - Rev A - 12/10
Maximum 127 positions are programmable. Any number between 1 and 128 can be
assigned to a Preset, except 95. Preset 95 is reserved for entering the OSD menu.
Camera parameters such as White Balance, Auto Exposure and others can be set up
independently and each preset can have its own parameter values independently from
other presets. When setting up presets with a controller, Label should be blank and
"Camera Adjust" should be set to "GLOBAL" as the default. To change the parameters,
enter the OSD menu.
Set Preset [1~128]
Go to Preset [1~128]
Use the OSD menu to delete Presets.
This function causes the camera to move repetitively between two preset positions at
programmed speeds. When the Swing function is enabled, the camera moves from the
Preset assigned as the first point to the Preset assigned as the second point in a clockwise
direction. Then the camera moves from the Preset assigned as the second point to the
Preset assigned as the first point in a counterclockwise (CCW) direction.
1st Preset
Where the Preset assigned as the first point and the Preset assigned as the second point
are same, the camera turns on its axis by 360° in a clockwise direction and then it turns
back on its axis by 360° in a counterclockwise direction. The Swing speed is defined from
1°/sec to 180°/sec.
To set a Swing, enter the OSD menu.
Method 1) <Run Pattern> [Swing no. + 10]
Method 2) <Go Preset> [Swing no. + 140]
To delete a Swing, enter the OSD menu.
Mini PTZ Dome Camera User Guide
2nd Preset
For example, Run Swing 3: <Run Pattern> [13]
For example, Run Swing 3: <Go Preset> [143]
27