Swing Setup - Honeywell 10X User Manual

Swing Setup

SWING SETUP
------------------------
SWING NO.
1ST POS.
2ND POS.
SWING SPEED
CLEAR SWING
RUN SWING
BACK
EXIT
Document 800-06705 - Rev A - 12/10
Swing Number
1
NOT USED
NOT USED
30/SEC
CANCEL
1st Position
2nd Position
Swing Speed
Clear Swing
Run Swing
Mini PTZ Dome Camera User Guide
[1~8]
Selects a Swing number to edit. If the selected
Swing is not defined, NOT USED is displayed in the
1st Position and the 2nd Position.
[PRESET 1~128]
Sets the two positions for a Swing function. If the
selected Preset is not defined, UNDEFINED is
displayed as shown below.
SWING SETUP
------------------------
SWING NO.
1ST POS.
2ND POS.
When a Swing function runs, the camera moves
from the Preset assigned as the first point to the
Preset assigned as the second point in a clockwise
direction. Then the camera moves from the Preset
assigned as the second point to the Preset
assigned as the first point in a counterclockwise
direction. Where the preset assigned as the first
point and the Preset assigned as the second point
are same, or only one Preset position is assigned,
the camera turns on its axis by 360° in a clockwise
direction and then it turns on its axis by 360° in a
counterclockwise direction.
[1°/sec. ~180°/sec.]
Defines Swing speed between the two Preset
positions from 1°/sec to 180°/sec
[CANCEL/OK]
Deletes the data of the selected Swing.
Runs Swing for test purposes to check if it works
properly.
1
PRESET5
NOT USED
UNDEFINED
41