Installation
In-Ceiling Mount Installation
Remove the ceiling tile from the ceiling and attach
the Guide Pattern to the ceiling tile. Then cut a hole
whose diameter is 116 mm and three holes for
M4x30 on the ceiling tile.
Align the dome cover stud with the stud on the main
body and slightly push the dome cover to the
ceiling tile.
Important Notice
Before starting the installation, make sure that the camera ID and protocol are set up properly.
18
Install the main body with the In-Ceiling Plate, the
three screws (M4x50) and the three nuts (M4).
Then install the ceiling tile to the ceiling and
connect the main cable to the main port.
Turn the dome cover clockwise and install the dome
cover lock-up screw. Then remove the protective
vinyl from the dome cover. (Machine M3×6)