Table of Contents
Advertisement
Introduction
Maximum 8 sets of Swing are programmable. The Swing function causes the camera to move
repetitively between two preset positions at programmed speeds.
Maximum 4 Patterns are programmable. The Pattern function causes the camera to memorize the
path (curve path) created by the controller joystick and to duplicate it as closely as possible.
Maximum 8 sets of Groups are programmable. The Group function causes the camera to memorize a
combination of Presets, Patterns and/or Swings and to run them repetitively in sequence. A Group can
consist of up to 20 Preset/Pattern/Swing functions.
Pan/Tilt/Zoom (PTZ) Control
Up to 255 cameras can be connected to a single controller using an RS-485 communication
connection.
Camera firmware supports Pelco-D control protocol.
On-Screen Display (OSD) Menu
OSD menu is provided to display the status of camera and to configure the functions interactively.
Information displayed on screen includes camera ID, pan/tilt angle, direction, and presets.
Reserved Presets (Hot Keys)
Most camera setup options can be set up easily and directly with the reserved presets (Hot Keys),
without entering the OSD menu. For more information, refer to "Reserved Presets (Hot Keys)" in this
manual.
12
Advertisement
Table of Contents
