Operation; Check Points Before Operation - Honeywell 10X User Manual

Operation

Checking Points before Operation
Before turning on the system, check if the wire(s) and cable(s) are connected properly.
Check if the camera ID on the controller is properly selected. The camera ID must be identical to that of the
target camera. The camera ID can be checked by reading the DIP switch of the camera or the OSD.
If your controller supports multiple protocols, the protocol must be changed to Pelco-D protocol.
Adjust the DIP switch after turning off the camera. If you changed the camera protocol by changing the DIP
switch, the change will be effective after you reboot the camera.
Since the operation method can be different depending on the controller, refer to your controller manual if the
camera cannot be controlled properly. The operation method described in this manual is based on a standard
Pelco® controller.
Using the Hot Keys with preset numbers for Pattern/Swing/Group. For more information, refer to "Reserved
Presets(Hot Keys)"in this manual.
Document 800-06705 - Rev A - 12/10
Mini PTZ Dome Camera User Guide
25