Using The Active A/V Network Feature - Mitsubishi VS-55601 Owner's Manual

Using the Active A/V Network Feature
This A/V Network is a special feature that makes it easier to use
your television and other Mitsubishi A/V components together.
When you connect the A/V Network, you can point the remote
control at the television, and it will pass the remote control com-
mand to other components.
You will gain even more benefits if you have a Mitsubishi YCR
equipped for the Active A/V Network. The Active A/V Network
allows you to perform many of the commonly used features of your
system at the press of just one button. This section explains the
various features of the Active A/V Network.
before you begin
I If you have installed TV GUIDE Plus+ on your TV, you can use the, VCR Plus+ feature to control your VCR for recording.
• You must have connected an A/V Network cable from the Active
A/V Network terminal of your TV to the "AN Network IN"
terminal of your VCR. See "TV+Mitsubishi Products that have
A/V Network Terminals" in Chapter 2.
• You must have connected your VCR to INPUT-1 of your TV.
• You must have set your TV A/V Network setting to Active or
Basic. See "Setting the A/V Network" in Chapter 3.
° Your VCR's remote control settings should be set to VCR-A.
• Your VCR video mute setting.should be turned ON.
what the Active A/V Network does
_>Important:
_>Important:
The Active A/V Network makes it easier and faster to use the VCR
Play command or display your VCR's menu.
When using the Active A/V Network, you should al_ays point your
remote control at your television.
If the TV is not receiving a signal on INPUT-l, it _ill automati-
cally turn offin about one or two minutes. If you use a TV menu
during this time, the TV will turn off in about five minutes after
you stop using the menus.
using the PLAY button
When you press PLAY on the remote:
• Active A/V Network will turn your VCR on and begin playing
the tape (if any).
• Active A/V Network will turn your TV on and switch it to
INPUT-1.
• When you turn your TV off, your VCR will turn off, _e_s it is
playing or recording.
displaying the VCR menu
When you set the remote to VCR A and then press MENU:
• theActiVeVCR'sA/Vmenu.Netw°rk will turn on your VCR if it is off and display
• toActiveINPUT.1.A/V Network will turn on your TV ifi_ is off and _w_,c_ _
Using the Active A/V Network Feature 97