Using The Active A/V Network Feature - Mitsubishi TS-4545 Owner's Manual

Using the active A/V Network feature (cont.)
DImportant:
DImportant:
DImportant:
using the PLAY button (AUTO PLAY)
When you press PLAY on the :remote:
• Active A/V Network will turn your VCR cn and begin playing
the tape (if any).
• Active AN Network will turn your TV on and switch it to EXT-
1.
When you turn your TV off:
• Your VCR will turn off, unless it is playing or recording.
using the PIP button (TWO TUNER PIP)
You must be watching a broadcast channel on Antenna-A or ,_m-
tenna-B to use the Active A/V Network PIP function correctly.
When you press the PIP buttcm on the remote to bring up a HP
image:
• Your VCR will automatically turn on.
• You can see the VCR's picture in the small PIP image.
While the PIP image is on the screen:
• The PIP function buttons (SOURCE, C,HANNEL, ENTER,
right/left, adjust up/down, PAUSE) will all work in the same
manner.
• Use the PIP Channel Selector to scan the PIP channels. To
access a channel directly, :you must select VCR-A on the remote
control, then use the number pad.
If you leave the TV turned on, set to EXT--1, but the TV is not
receiving a signal on EXT-1, :it will automatically turn off after five
minutes. (If you use a TV menu during this time, the TV will turn
off five minutes after you stop using the menus.)
You should not press the PIP button while you are watching a
channel that is not receiving any broadcasts. YOUwill not be able
to see the small PIP image, and you will not be able to change
channels on the main image. You may need to turn off the 'FV and
turn it back on, change to a channel that is receiving a broadcast,
and begin again.
Using the Active A/V Network 99