Mitsubishi VS-55601 Owner's Manual page 27

TV + separate UHF and VHF antennas
equipment you will need
If UHF and VHF signals are brought into your home with two
separate antennas you'll need to combine them :in order to connect
them to the TV. To do this you will need a UHF/VHF combiner.
(There are different combiners for different kinds of wires. Check
with your local electronics store for the kind of corabiner you need.)
Pictured to the right is a
standard combiner with the
following specifications:
Two (2) 300 ohm inputs
One (1) 75 ohm output
UHF
VHF
I _ 75 OHM Out
To connect separate UHF and VHF antennas to your TV:
O Connect the UHF and VHF antenna leads to the appropriate
terminals on the UHF/VHF combiner.
Press the combiner onto the ANT-A terminal on the rear of the
TV.
VHF Antenna
(Channels 2-13)
-- Flat Twin Lead
External
Antenna
or Cable
UHF Antenna
(Channels 14-69)
Flat Twin Lead -
L__ 300 Ohm to
_oSmOhnmer
Back Side
TV Rear Terminal
CASLE
ANT-A LOOP-OUT ANT -B
@@
ACTIVE NV IWG
NETWORK UNK
® ®
26 Chapter 2: Connecting Your TV