Mitsubishi VS-55601 Owner's Manual page 59

AV
Setting the A/V Network
The A/V Network is a system that Mitsubishi developed to make it
easier to operate many products with one remote cont_:ol. When the
A/V Network is connected between two Mitsubishi products, you can
point the remote control at one product and it will "pass" the remote
control command to the other. In addition, Active A/V Network will
automate the TV's input selection and the playback of Mitsubishi
VCRs into a single command. To set up the __V Network:
[] TV Main Menu
_] First Time Setup V"--_]
[] Customize Display
[_-'] Advanced Features
[] Select A/V Memory
[]Guide Plus+ Menu
_'] ADJUST to select
_q ENTER to enter
F_q MENU to exit menus
[] Set A/V Network l--1
[] Basic
[] Active
F_ ADJUST to setect
ENTER to enter
MENU to go back
O Press the MENU button. The
Main Menu will appear on the
screen.
O Use the ADJUS[[ _buttons to
select "First Time Setup."
Press ENTER!EXCH.
Use ADJUST to select "Set A/V
Network:" then press ENTER/
EXCH.
Use the ADJUST buttons to
select "Active," "Basic," or "Off."
Check the rear terminals of your
VCR, then use tile chart below to
determine how you should set
your TV.
If your VCR has a rear ...and you have set your ...then set your TV to:
terminal that reads: VCR to:
A/V Network - Basic
Active A/V Network Off Basic
Active A/V Network Active Active
Does not have an A/V - Off
Network rear terminal
_>Important:
[_Important:
_Important:
O Press the ENTER/EXCH or MENU button to return to the
"First Time Setup" menu. Press HOME to exit all menus.
If you are not sure how to set your VCR's A/V Network
setting, refer to your VCR's owner's guide.
The A/V Network can still be used to pass remote control signals
even when the TV's "A/V Network" setting is "Off'.
If you do not use the A/V Network system, set "A/V Network" to
"Off'. If you don't, channel selection may not work correctly.
If you select Active or Basic A/V settings, make sure your Mitsub-
ishi VCR with an A/V Network or Active A/V Network connection is
connected to Input-1 and the AN network cable is in place.
Getting Started 59