Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 70

Removing or Replacing Cisco Network Modules for Cisco Access Routers
Step 1 Initiate a console session with your Cisco access router.
Step 2 Enter interface configuration mode and shut down each interface on the network module you plan to
remove. (See
Example 2-1
Router(config)# interface fastethernet 1/0
Router(config-if)# shutdown
To see information for all interfaces available on the network module, use the show interfaces
Tip
command.
Repeat
Step 3
Unplug all cables from the network module.
Step 4
To make it easier to work with network cables, label the cables or prepare a network cabling diagram
Timesaver
before removing network interface cables from the network module.
Remove the network module as described in the
Step 5
Single-Wide, and Extension Voice Network Modules from Cisco Access Routers"
Replacing Double-Wide and Extended Double-Wide Network Modules in Cisco Access Routers"
sections.
Install a replacement network module. If you are not planning to install another network module at this
Step 6
time, install a blank faceplate over the network module slot. (See the
Cisco Access Routers" section on page
Step 7 Connect the cables removed from the previous network module.
Confirm that the network module LEDs come on, and that the Active/Ready LEDs on the front panel of
Step 8
the router also come on. For further information on network module LEDs, see the chapter describing
your specific network module.
Step 9 Initiate a console session with your Cisco access router.
Enter interface configuration mode and activate each interface on the network module, as shown in
Step 10
Example
Example 2-2
Router(config)# interface fastethernet 1/0
Router(config-if)# no shutdown
Step 11 Repeat
Removing or Replacing Application and Service Network Modules
Application and service network modules use hard disks and require special software procedures prior
to removal or replacement.
Cisco Network Modules Hardware Installation Guide
2-22
Example 2-1.)
Shutting Down Interfaces on Cisco Network Modules
Step 2 for each interface on the network module.
2-2.
Activating Interfaces on Cisco Network Modules
Step 10 for every interface on the network module.
Chapter 2 Installing Cisco Network Modules in Cisco Access Routers
"Removing or Replacing Single-Wide, Extended
2-7.)
and "Removing or
"Installing Blank Faceplates on
OL-2485-20