Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 291

Connecting Circuit Emulation Over IP Network
Modules
This chapter describes how to connect circuit emulation over Internet Protocol (CEoIP) network
modules and contains the following sections:
•
•
•
•
•
To determine whether your router supports a specific network module, see
Tip
Cisco CEoIP Network Modules
Cisco CEoIP network modules provide a virtual circuit through an IP network (similar to a leased line).
Transport of data, regardless of the content or structure of the data stream, is entirely transparent to the
destination; bits arriving at one end are delivered unchanged to the destination address.
This chapter provides information on the following two Cisco CEoIP network modules:
•
•
OL-2485-20
Cisco CEoIP Network Modules, page 27-1
4-Port Serial Interface Network Modules (NM-CEM-4SER), page 27-2
Connecting 4-Port Serial Interface Network Modules to the Network, page 27-3
4-Port T1/E1 RJ-48 Interface Network Modules (NM-CEM-4TE1), page 27-9
Connecting 4-Port T1/E1 RJ-48 Interface Network Modules (NM-CEM-4TE1) to the Network, page
27-9
4-port serial interface network module (NM-CEM-4SER), shown in
4-port T1/E1 RJ-48 interface network module (NM-CEM-4TE1), shown in
C H A P T E R
Figure 27-1
Cisco Network Modules Hardware Installation Guide
27
Table 1-6 on page 1-16.
Figure 27-2
27-1