Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 357

Chapter 33 Connecting Cisco IP VSAT Satellite WAN Network Modules
Prerequisites
•
•
Restrictions
Only use the power supply provided in the Gilat ODU kit. Use of any other power supply will void the
warranties for your NM-1VSAT-GILAT network module and outdoor equipment.
Steps
To connect the NM-1VSAT-GILAT network module to the external power supply, follow these steps:
Connect the power supply cable to the ODU PWR connector on the NM-1VSAT-GILAT
Step 1
network module. (See
Connect the power supply to a general-purpose electrical outlet. (For the United States, see
Step 2
For Europe, see
Figure 33-6
OL-2485-20
Install the NM-1VSAT-GILAT network module in the router chassis. See the
Network Modules in Cisco Access
Installation Guide.
Connect the NM-1VSAT-GILAT network module to the ODU. See the
NM-1VSAT-GILAT Network Module to the ODU" section on page
Figure 33-6.)
Figure 33-7.)
Connecting the NM-1VSAT-GILAT Network Module to the Power Supply (USA)
NM-1VSAT
GILAT
RF-IN
EXT
DC
Step 2
How to Install, Connect, or Replace the NM-1VSAT-GILAT Network Module
Routers" chapter of the Cisco Network Modules Hardware
ODU PWR
RF-OUT
RX ON
LOCK SYNC TX
LINE
Step 1
Cisco Network Modules Hardware Installation Guide
"Installing Cisco
"Connecting the
33-10.
EN
Figure 33-6.
33-13