Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 418

Additional References
Restore the running configuration of the network module by using the following command from the
Step 15
service module prompt:
SE-Module# copy tftp running-config tftp-server-address filename
Exit the network module session by pressing Control-Shift-6, followed by pressing x.
Step 16
On the router, clear the network module session by using the following command:
Step 17
Router# service-module integrated-Service-Engine slot / unit session clear
Additional References
For additional information, see the following documents and resources.
Related Topic
Regulatory compliance and safety
information
Cisco Analog Video Gateway software
website and reference documentation
Cisco Video Management and Storage
System software website and reference
documentation
Cisco Video Management and Storage
System network module (NME-VMSS)
hardware documentation
Cisco product support and technical
documentation
Technical documentation, including
feedback and assistance
Cisco Network Modules Hardware Installation Guide
40-6
Chapter 40 Cisco Video Management and Storage System Enhanced Network Modules
Document Title
Cisco Network Modules and Interface Cards Regulatory Compliance and Safety
Information
Cisco Network Modules Configuration Guides
http://www.cisco.com/en/US/products/hw/modules/ps2797/products_installati
on_and_configuration_guides_list.html
Cisco Network Modules Configuration Guides
http://www.cisco.com/en/US/products/hw/modules/ps2797/products_installati
on_and_configuration_guides_list.html
Cisco Network Modules Install and Upgrade Guides
http://www.cisco.com/en/US/products/hw/modules/ps2797/prod_installation_g
uides_list.html
Product Support
http://www.cisco.com/web/psa/products/index.html
What's New in Cisco Product Documentation (including monthly listings of new
and revised documents) at
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
OL-2485-20