Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 259

Chapter 21 Connecting Gigabit Ethernet Network Modules
Step 1 Hold down the clips on the side of the GBIC while inserting the GBIC into the GBIC slot in the network
module faceplate. (See
Figure 21-2 Installing a GBIC into a Network Module
NM-1GE
Release the side clips on the GBIC.
Step 2
Connect the Gigabit Ethernet network module to the network. (See
Step 3
in an uninstalled network module, install the network module (see
Modules in Cisco Access
Laser Safety Guidelines
Optical GBICs use a small laser to generate the fiber-optic signal. Keep the transmit port covered
whenever a cable is not connected to the port.
The module faceplate carries a Class 1 laser warning label. (See
Figure 21-3 Class 1 Laser Warning Label
CLASS 1 LASER PRODUCT
LASERPRODUKT DER KLASSE 1
NM-1GE
Because invisible laser radiation may be emitted from the aperture of the port when no fiber cable
Warning
is connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 240
OL-2485-20
Figure 21-2.)
GBIC
Routers") before connecting the network module to the network.
GBIC
EN
Chapter 2, "Installing Cisco Network
Figure
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
CLASS 1 LASER PRODUCT PRODUCT LASER DE CLASSE1
LASERPRODUCT DER KLASSE 1 PRODUCTO LASER CLASE 1
EN
Cisco Network Modules Hardware Installation Guide
Gigabit Ethernet Network Modules
Figure 21-4.) If installing the GBIC
21-3.)
21-3