Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 306

Connecting Cisco High-Density Extension Modules to the Network
Figure 28-3 Label Locations for Expansion Modules on Cisco High-Density Expansion Modules
EVM-HD
Install the network module into the router. (See the
Step 7
Routers" section on page
Connecting Cisco High-Density Extension Modules to the
Network
The Cisco high-density extension module is connected to a distribution frame or patch panel with an
RJ-21 cable. (See
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 8-port analog voice/fax expansion module (EM-HDA-8FXS) and 4-port digital voice/fax
expansion module (EM-4BRI-NT/TE) only to intrabuilding or nonexposed wiring or cabling. The
intrabuilding cable must be shielded and the shield must be grounded at both ends.
For ordering information, see the
Cisco Network Modules Hardware Installation Guide
28-6
Apply label for EM0 here
8FXS/DID
EM
None
0
EM
None
1
EM0 EM1
Apply label for EM1 here
2-5.)
Figure 28-4.) RJ-21 cables are not provided with the network module.
Chapter 28
26
1
"Installing Cisco Network Modules in Cisco Access
"Obtaining Technical Assistance" section on page
Connecting Cisco High-Density Extension Modules
xi.
OL-2485-20