Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 379

Chapter 35 Connecting Application Performance Assurance Enhanced Network Modules
Confirm that the NME-APA is running by using the following command:
Step 9
Router# service-module integrated-service-engine slot / unit status
Service Module is Cisco Integrated-Service-Engine1/0
Service Module supports session via TTY line 66
Service Module is in Steady state
Getting status from the Service Module, please wait.
Network Module Enhanced - Application Performance Assurance 0.1.2.1
NME-APA running on BRYCE
Exit the router Telnet session:
Step 10
Router # exit
Configuring the Replacement NME-APA
Follow these steps to configure the replacement module exactly like the original.
The module will not respond to Telnet commands until it has finished restarting. You must wait several
minutes before performing
If you have not performed the
Step 1
perform the procedure now.
Telnet to the NME-APA:
Step 2
Router# telnet 10.10.10.2
Trying 10.10.10.2...
Connected to 10.10.10.2.
Escape character is '^]'.
User Access Verification
Username:
Password:
NME-APA> enable
Password:
NME-APA#
Step 3 Restore the network module's running configuration from the file saved in the
Configuration File" procedure on page 35-4
prompt:
NME-APA# copy ftp://[[[username[:password]@]location]/directory]/backup.config
NME-APA# copy /directory/source-file /directory/destination-file
NME-APA# copy running-config startup-config
Step 4 Exit the network module session by using the following command:
NME-APA# logout
Step 2. The exact time depends on the system configuration.
"Saving the NME-APA Configuration File" procedure on page
by using the following command from the service module
Cisco Network Modules Hardware Installation Guide
Online Insertion and Removal of NME-APA-E3
"Saving the NME-APA
35-4,
35-7