Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 308

Connecting Cisco High-Density Extension Modules to the Network
Figure 28-5 Black Box Patch Panel (JPM2194A) for Use with Cisco High-Density Expansion Modules
1
RJ-11 receptacles for FXS/DID ports on the
EVM-HD-8FXS/DID baseboard.
2
RJ-11 receptacles for FXS/DID ports on the
EVM-HD-8FXS/DID baseboard.
3
RJ-11 receptacles for FXS or FXO ports on an
FXS or FXO expansion module when
installed in slot EM0.
Note
Table 28-2
Table 28-2 Pinouts for RJ-11 and RJ-45 Receptacle Types
Receptacle Type
RJ-11
RJ-45
Cisco Network Modules Hardware Installation Guide
28-8
1
EM0
8 9
0 1 2 3
BASE BASE ASE
EM0
4 5 6 7
2
Applies to EM-HDA-8FXS,
EM-HDA-6FXO, or
EM-HDA-3FXS/4FXO expansion
modules only.
provides pin definitions for the RJ-11 and RJ-45 receptacle types:
Pin Definitions
Pi n 3 = Ri ng
Pi n 4 = Ti p
Pi n 3 = I SD N BRI - S/ T Bus Tr ans m i t +
Pi n 4 = I SD N BRI - S/ T Bus Recei ve+
Pi n 5 = I SD N BRI - S/ T Bus Recei ve–
Pi n 6 = I SD N BRI - S/ T Bus Tr ans m i t –
Chapter 28 Connecting Cisco High-Density Extension Modules
3
EM1
10 11 12 13 14 15 16 17
EM1
8 9 10 11
4
4
RJ-45 receptacles for BRI ports on the
EM-4BRI-NT/TE when installed in slot EM0.
5
RJ-11 receptacles for FXS or FXO ports on an
FXS or FXO expansion module when
installed in slot EM1.
Note
6
RJ-45 receptacles for BRI ports on the
EM-4BRI-NT/TE when installed in slot EM1.
5
18 19 20 21 22 23
12 13 14 15
6
Applies to EM-HDA-8FXS,
EM-HDA-6FXO, or
EM-HDA-3FXS/4FXO expansion
modules only.
OL-2485-20