Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 336

Related Documents
Enter the User ID and password at the WLAN controller prompt:
Step 4
User: admin
Password: *****
(WLAN-Controller) >
Set the TFTP server IP address from the WLAN controller module console access session:
Step 5
(WLAN-Controller) > transfer download serverip 192.0.2.24
Set the datatype configuration using the following command:
Step 6
(WLAN-Controller) > transfer download datatype configuration
Set the running configuration file using the following command:
Step 7
(WLAN-Controller) > transfer download filename < config-running.bin >
Start the TFTP transfer using the following command:
Step 8
(WLAN-Controller) > transfer download start
Mode............................................. TFTP
TFTP Server IP................................... 192.0.2.24
TFTP Path........................................ /
TFTP Filename.................................... config-running.bin
Data Type........................................ Config File
Encryption....................................... Disabled
**************************************************
***
**************************************************
Are you sure you want to start? (y/n) y
Tftp Config transfer starting.
File transfer operation completed successfully.
(WLAN-Controller) >
Note
Related Documents
For additional information, see the following documents.
For information on obtaining documentation, see the
Tip
For information on obtaining technical assistance, see the
page
Cisco Network Modules Hardware Installation Guide
31-6
WARNING: Config File Encryption Disabled
After the successful file transfer, the WLAN controller module automatically reboots.
xi.
Chapter 31 Connecting Cisco Wireless LAN Controller Modules
***
"Obtaining Documentation" section on page
"Obtaining Technical Assistance" section on
viii.
OL-2485-20