Related Documents - Cisco CISCO2650 - 2650 Router Hardware Installation Manual

Chapter 33 Connecting Cisco IP VSAT Satellite WAN Network Modules
Connect the RF cables to the RF-IN and RF-OUT connectors on the NM-1VSAT-GILAT network
Step 12
module.
Connect the power supply cable to the ODU PWR connector on the NM-1VSAT-GILAT network
Step 13
module.
Reconnect all other network cables, including telephone cables, to the rear panel of the router.
Step 14
Confirm that the NM-1VSAT-GILAT network module LEDs come on. For more information about the
Step 15
LEDs, see the
What to Do Next
Configure the initial VSAT parameters for the new NM-1VSAT-GILAT network module. See the
Cisco IP VSAT Satellite WAN Network Module (NM-1VSAT-GILAT)
Satellite initial configuration mode can only be accessed by a password that is unique to each
Note
NM-1VSAT-GILAT network module. If an installation technician does not configure the initial VSAT
parameters, then your satellite service provider will provide the password for your new
NM-1VSAT-GILAT network module.

Related Documents

Related Topic
Regulatory compliance and safety
information
Cisco IOS software configuration for the
NM-1VSAT-GILAT network module
Platform documentation for the Cisco 2600
series, Cisco 2800 series, Cisco 3700 series,
and Cisco 3800 series routers
Cisco IOS release notes
OL-2485-20
"NM-1VSAT-GILAT Network Module LEDs" section on page
Document Title or URL
Cisco Network Modules and Interface Cards Regulatory Compliance and
Safety Information
Cisco IP VSAT Satellite WAN Network Module (NM-1VSAT-GILAT)
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/index.htm
http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123relnt/
Cisco IOS feature module.
Cisco Network Modules Hardware Installation Guide
Related Documents
33-7.
33-19