Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 272

Online Insertion and Removal with a Cisco Unity Express Network Module
On the router, clear the Cisco Unity Express network module console access session by using the
Step 4
following command:
Router# service-module service-engine slot / port session clear
Perform a graceful halt of the Cisco Unity Express network module disk drive by using the following
Step 5
command:
Router# service-module service-engine slot / port shutdown
Loosen the two captive screws holding the Cisco Unity Express network module in the chassis slot.
Step 6
Step 7 Slide the Cisco Unity Express network module out of the slot.
Step 8 Align the replacement Cisco Unity Express network module with the guides in the chassis slot, and slide
it gently into the slot.
Note
Step 9 Push the module into place until you feel its edge connector mate securely with the connector on the
backplane.
Tighten the two captive screws on the module faceplate.
Step 10
Step 11 Check that the network module LEDs come on and that the power and enable LEDs on the front panel
have also come on. This inspection ensures that connections are secure and that the new unit is operational.
Initiate a Cisco Unity Express network module console access session with the following command:
Step 12
Router# service-module service-engine slot / port session
Trying 10.10.10.1, 2129 ... Open
SE-netmodule con now available
Press RETURN to get started!
SE-netmodule> enable
SE-netmodule#
Restore the Cisco Unity Express running configuration by using the following command from the
Step 13
SE-netmodule prompt:
SE-netmodule# copy ftp: running-config
Address or name or remote host? username/password/remote host
Source filename? filename
Step 14 Exit the Cisco Unity Express network module console access session by pressing Ctrl-Shift-6, followed
by x.
On the router, clear the console access session using the following command:
Step 15
Router# service-module service-engine slot / port session clear
Cisco Network Modules Hardware Installation Guide
23-4
If the router is not fully configured with network modules, make sure that blank panels fill the
unoccupied chassis slots to provide proper airflow.
Chapter 23 Connecting Cisco Unity Express Network Modules
OL-2485-20