Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 247

Chapter 19 Connecting Content Engine Network Modules for Caching and Content Delivery
RJ-45 cables are not available from Cisco Systems. These cables are widely available and must be
Note
Category 5 cables.
Figure 19-3 Connecting a CE Network Module to a Fast Ethernet Hub
Category 5
or UTP cable
Connecting CE Network Modules with SCSI Controller Expansion Modules to
an External Cisco Storage Array
Connecting the external Cisco storage array requires you to reboot the network module or router. To save
Timesaver
time, connect the external Cisco storage array to the CE network module before powering on the router
or network module.
To connect a CE network module with a SCSI controller expansion module to an external storage array,
use a 68-pin, low-voltage differential (LVD) SCSI cable. Connect the cable to the SCSI port on the
network module to the SCSI port on the external Cisco storage array. (See
Cisco Storage Array 6 is supported on the CE network module with SCSI controller expansion module.
(See the
Use either a 36- or 108-inch LVD SCSI cable, depending on the length required between the router and
Tip
the external storage array.
OL-2485-20
NM-CE-B P
DISK
LINK
ACT
EN
PWR
FastEthern et 0
Fast Ethernet
RJ-45
Cisco Storage Array 6 Installation and Configuration
CF
Fast Ethernet hub
Guide.)
Cisco Network Modules Hardware Installation Guide
CE Network Modules
Figure 19-4.)
19-3