Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 284

Related Documents
Unplug the network interface cable from the network analysis module.
Step 3
Loosen the two captive screws holding the network analysis module in the chassis slot.
Step 4
Step 5 Remove the network analysis module from the slot.
Step 6 Align the replacement network analysis module with the guides in the chassis slot, and slide it gently
into the slot.
Note
Step 7 Push the module into place until you feel the edge connector mate securely with the connector on the
backplane.
Step 8 Reconnect the network interface cable previously removed in
Tighten the two captive screws on the faceplate.
Step 9
Reset the network analysis module using the reset command.
Step 10
Router# service-module analysis-module slot /0 reset
Use reset only to recover from shutdown or failed state
Warning: May lose date on the hard disc!
Do you want to reset?[confirm]
Press Enter to confirm the request. The network analysis module resets itself.
Step 11
Check that the network module LEDs are on and that the power and enable LEDs on the front panel also
Step 12
are on. This inspection ensures that connections are secure and that the new unit is operational.
Related Documents
For additional information, see the following documents.
For information on obtaining documentation, see the
Tip
For information on obtaining technical assistance, see the
page
Cisco IOS Software Documentation
For information on Cisco IOS software configuration, see the
document.
Cisco Network Modules Hardware Installation Guide
25-4
If the router is not fully configured with network modules, make sure that blank panels fill the
unoccupied chassis slots to provide proper airflow.
xi.
Chapter 25 Connecting Cisco Network Analysis Modules
Step 3.
"Obtaining Documentation" section on page
"Obtaining Technical Assistance" section on
Network Analysis Module (NM-NAM)
viii.
OL-2485-20