Cisco CISCO2650 - 2650 Router Hardware Installation Manual page 270

Cisco Unity Express Network Module LEDs
Figure 23-1 NM-CUE Faceplate
NM-CUE
Cisco Unity Express Network Module LEDs
All network modules have an enable (EN) LED. This LED indicates that the module has passed its
self-tests and is available to the router.
All Cisco Unity Express network modules display an additional power (PWR) LED and a CompactFlash
(CF) LED on the faceplate, and two additional LEDs for the Fast Ethernet port. (See
Table
Note The CF and Fast Ethernet port LEDs are not used by the Cisco Unity Express network module.
Figure 23-2 NM-CUE LEDs
DISK
NM-CUE
PWR
Table 23-1 Cisco Unity Express Network Module LEDs
LED
ACT
CF
DISK
EN
LINK
PWR
Cisco Network Modules Hardware Installation Guide
23-2
DISK
NOT SUPPORTED
LINK ACT
EN
PWR
FastEthernet 0
23-1.)
LINK ACT
DISK
NOT SUPPORTED
LINK ACT
EN
PWR
FastEthernet 0
EN
Meaning
There is activity on the Fast Ethernet connection.
This LED is not used on the NM-CUE.
Note
The compact Flash module is active.
This LED is not used on the NM-CUE.
Note
There is activity on the 20-GB disk-expansion module hard drive.
The module has passed self-test and is available to the router.
The Fast Ethernet connection is available to the network module.
This LED is not used on the NM-CUE.
Note
Power is available to the network module.
Chapter 23 Connecting Cisco Unity Express Network Modules
CF
CF
CF
Figure 23-2 and
OL-2485-20