Disabling Storm Control; Displaying Storm Control - Cisco 4500M Software Manual

Disabling Storm Control

Disabling Storm Control
To disable storm control, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# interface
interface-id
Step 3
Switch(config-if)# no storm-control
broadcast level
Step 4
Switch(config-if)# no storm-control
{
action shutdown
Step 5
Switch(config-if)# exit
Step 6
Switch(config)# end
Step 7
Switch# show storm-control
broadcast
Step 8
Switch# copy running-config
startup-config
The following example shows how to disable storm control on interface.
Switch# conf t
Enter configuration commands, one per line.
Switch(config)#int fa3/1
Switch(config-if)# no storm-control broadcast level
Switch(config-if)# end
Switch# wr
Building configuration...
00:12:09: %SYS-5-CONFIG_I: Configured from console by consoleCompressed configuration from
5357 bytes to 1594 bytes[OK]
Switch# sh sto
Switch# sh storm-control
Interface
---------
Switch#

Displaying Storm Control

Use the show interface capabilities command to determine the mode in which storm control is
Note
supported on an interface.
The following example shows an interface that supports broadcast suppression in software (sw).
Switch# show interfaces g4/4 capabilities
show interfaces g4/4 capabilities
GigabitEthernet4/4
Model:
Type:
Software Configuration Guide—Release 12.2(25)EW
38-4
Purpose
Enters global configuration mode.
Enters interface configuration mode and enter the port to configure.
Disables port storm control.
Disables the specified storm control action and returns to default filter
| }
trap
action.
Returns to configuration mode.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Filter State Upper
------------- -------
WS-X4418-Gbic
1000BaseSX
Chapter 38
End with CNTL/Z.
Lower Current
------- -------
Configuring Port-Based Traffic Control
OL-6696-01