Configuring EtherChannel
Removing an EtherChannel
If you remove an EtherChannel, the member ports are shut down and removed from the Channel group.
Note
You must remove an EtherChannel before changing a port from Layer 2 to Layer 3, or Layer 3 to Layer 2.
To remove an EtherChannel, perform this task:
Command
Step 1
Switch(config)# no interface port-channel
port_channel_number
Step 2
Switch(config)# end
Step 3
Switch# show etherchannel summary
This example shows how to remove port-channel 1:
Switch# configure terminal
Switch(config)# no interface port-channel 1
Switch(config)# end
Software Configuration Guide—Release 12.2(25)EW
17-14
Chapter 17
Understanding and Configuring EtherChannel
Purpose
Removes the port-channel interface.
Exits configuration mode.
Verifies the configuration.
OL-6696-01