Cisco 4500M Software Manual page 466

Configuring DHCP Snooping on the Switch
The switch maintains two sets of counters for these ignored bindings. One provides the counters for a
read that has at least one binding ignored by at least one of these conditions. These counters are shown
as the "Last ignored bindings counters." The total ignored bindings counters provides a sum of the
number of bindings that have been ignored because of all the reads since the switch bootup. These two
set of counters are cleared by the clear command. Therefore, the total counter set may indicate the
number of bindings that have been ignored since the last clear.
Example 2: Reading Binding Entries from a TFTP File
To manually read the entries from a TFTP file, perform this task:
Command
Step 1
Switch# sh ip dhcp snooping database
Step 2
Switch# renew ip dhcp snoop data url
Step 3
Switch# sh ip dhcp snoop data
Step 4
Switch# sh ip dhcp snoop bind
This is an example of how to manually read entries from the tftp://10.1.1.1/directory/file:
Switch# sh ip dhcp snooping database
Agent URL :
Write delay Timer : 300 seconds
Abort Timer : 300 seconds
Agent Running : No
Delay Timer Expiry : Not Running
Abort Timer Expiry : Not Running
Last Succeded Time : None
Last Failed Time : None
Last Failed Reason : No failure recorded.
Total Attempts
Successful Transfers :
Successful Reads
Successful Writes
Media Failures
Switch#
Switch# renew ip dhcp snoop data tftp://10.1.1.1/directory/file
Loading directory/file from 10.1.1.1 (via GigabitEthernet1/1): !
[OK - 457 bytes]
Database downloaded successfully.
Switch#
00:01:29: %DHCP_SNOOPING-6-AGENT_OPERATION_SUCCEEDED: DHCP snooping database Read
succeeded.
Switch#
Switch# sh ip dhcp snoop data
Agent URL :
Write delay Timer : 300 seconds
Abort Timer : 300 seconds
Agent Running : No
Delay Timer Expiry : Not Running
Abort Timer Expiry : Not Running
Software Configuration Guide—Release 12.2(25)EW
33-8
Purpose
Displays the DHCP snooping database agent statistics.
Directs the switch to read the file from given URL.
Displays the read status.
Verifies whether the bindings were read successfully.
: 0 Startup Failures :
0 Failed Transfers :
: 0 Failed Reads
: 0 Failed Writes
: 0
Chapter 33 Configuring DHCP Snooping and IP Source Guard
0
0
: 0
: 0
OL-6696-01