Cisco 4500M Software Manual page 258

Configuring EtherChannel
Command
Step 5
Switch(config-if)# end
Step 6
Switch# show running-config interface port-channel
port_channel_number
Switch# show running-config interface {fastethernet
| gigabitethernet | tengigabitethernet} slot / port
Switch# show interfaces {fastethernet |
gigabitethernet | tengigabitethernet} slot / port
etherchannel
Switch# show etherchannel 1 port-channel
This example shows how to configure Fast Ethernet interfaces 5/4 and 5/5 into port-channel 1 with PAgP
mode desirable:
Switch# configure terminal
Switch(config)# interface range fastethernet 5/4 - 5 (Note: Space is mandatory.)
Switch(config-if)# no switchport
Switch(config-if)# no ip address
Switch(config-if)# channel-group 1 mode desirable
Switch(config-if)# end
See the
Note
keyword.
The following two examples shows how to verify the configuration of Fast Ethernet interface 5/4:
Switch# show running-config interface fastethernet 5/4
Building configuration...
Current configuration:
!
interface FastEthernet5/4
no ip address
no switchport
no ip directed-broadcast
channel-group 1 mode desirable
end
Switch# show interfaces fastethernet 5/4 etherchannel
Port state
Channel group = 1
Port-channel
Port indx
Flags:
Timers: H - Hello timer is running.
Local information:
Port
Fa5/4
Software Configuration Guide—Release 12.2(25)EW
17-8
"Configuring a Range of Interfaces" section on page 4-4
= EC-Enbld Up In-Bndl Usr-Config
Mode = Desirable
= Po1 GC
= 0 Load = 0x55
S - Device is sending Slow hello.
A - Device is in Auto mode.
S - Switching timer is running.
Flags State Timers
SC U6/S7
Chapter 17
Purpose
Exits configuration mode.
Verifies the configuration.
Gcchange = 0
= 0x00010001 Pseudo-port-channel = Po1
C - Device is in Consistent state.
P - Device learns on physical port.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner PAgP
Interval Count Priority
30s 1 128
Understanding and Configuring EtherChannel
for information about the range
Learning Group
Method Ifindex
Any 55
OL-6696-01