Creating An Rspan Destination Session And Enabling Ingress Traffic - Cisco 4500M Software Manual

Chapter 39 Configuring SPAN and RSPAN
Command
Step 5
Switch# show monitor [session
session_number ]
Step 6
Switch# copy running-config
startup-config
This example shows how to configure VLAN 901 as the source remote VLAN and port 5 as the
destination interface:
Switch(config)# monitor session 1 source remote vlan 901
Switch(config)# monitor session 1 destination interface gigabitEthernet1/2
Switch(config)# end

Creating an RSPAN Destination Session and Enabling Ingress Traffic

To create an RSPAN destination session, to specify the source RSPAN VLAN, and to enable ingress
traffic on the destination port for a network security device (such as a Cisco IDS [Intrusion Detection
System] sensor appliance), perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# monitor session
{ session_number } source vlan vlan_IDs
OL-6696-01
Purpose
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enters global configuration mode.
Specifies the RSPAN session and the source RSPAN VLAN.
For session_number, specifies the session number identified with this
RSPAN session (1 through 6).
For vlan_IDs, specifies the source VLAN or VLANs to monitor.
Valid VLANs are in the range from 1 to 4094.
Software Configuration Guide—Release 12.2(25)EW
Configuring RSPAN
39-19