Displaying Auto-Qos Information - Cisco 4500M Software Manual

Chapter 29 Configuring QoS
This example shows how to display the QoS commands that are automatically generated when auto-QoS
is enabled:
Switch# debug auto qos
AutoQoS debugging is on
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/1
Switch(config-if)# auto qos voip cisco-phone

Displaying Auto-QoS Information

To display the initial auto-QoS configuration, use the show auto qos [interface [interface-id]]
privileged EXEC command. To display any user changes to that configuration, use the show
running-config privileged EXEC command. You can compare the show auto qos and the show
running-config command output to identify the user-defined QoS settings.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
•
•
•
For more information about these commands, refer to the command reference for this release.
OL-6696-01
show qos
show qos map
show qos interface [interface-id]
Software Configuration Guide—Release 12.2(25)EW
Configuring Auto-QoS
29-19