User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to
the default value.
Default
Format
Mode
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default
Format
Mode
no remotecon timeout
This command sets the remote connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default 5
Format
Mode
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
Switching Commands
5
no remotecon maxsessions
Privileged EXEC
5
remotecon timeout <0-160>
Privileged EXEC
no remotecon timeout
Privileged EXEC
9600
December 2004, 202-10010-02
8-21