User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default
Format
Mode
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
Mode
dot1x system-auth-control
This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
Default
Format
Mode
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format
Mode
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine on
this port. Depending on the token used and the value (in seconds) passed, various timeout
configurable parameters are set. The following tokens are supported.
8-98
Disabled
dot1x re-authentication
Config
Interface
no dot1x re-authentication
Interface Config
Disabled
dot1x system-auth-control
Global Config
no dot1x system-auth-control
Global Config
December 2004, 202-10010-02
Switching Commands