User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP clients.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Default
Format
Mode
no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Format
Mode
ip dhcp ping packets
This command is used to specify the number in a range from 2-10, of packets a DHCP server sends
to a pool address as part of a ping operation. Setting the number of ping packets to 0 is the same as
'no ip dhcp ping packets' and will prevent the server from pinging pool addresses.
Default
Format
Mode
no ip dhcp ping packets
This command prevents the server from pinging pool addresses and will set the number of packets
to 0.
Default
Format
Mode
9-4
None
ip dhcp excluded-address <lowaddress> [highaddress]
Global Config
no ip dhcp excluded-address <lowaddress> [highad-
dress]
Global Config
2
ip dhcp ping packets <0,2-10>
Global Config
0
no ip dhcp ping packets
Global Config
December 2004, 202-10010-02
DHCP Server Commands