NETGEAR ProSafe GSM7212 User Manual page 40

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
• Web Browser
Note: The user should do a copy system:running-config nvram:startup-config after
configuring the network parameters so that the configurations are not lost
Table 6-4. Quick Start up IP Address
Command
show network
(in User EXEC)
network parms
(in Privileged EXEC)
Note: The IP address assigned to
management CPU via the routable interface is desired, use the
6-4
Details
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for in-
band connectivity
Network Configurations Protocol Current - Indicates which network
protocol is being used
Default is none
Management VLAN Id - Specifies VLAN id
Web Mode - Indicates whether HTTP/Web is enabled.
Java Mode - Indicates whether java mode is enabled.
network parms <ipaddr> <netmask> [<gateway>]
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255
in the above table will not be routable. If access to
network
December 2004, 202-10010-02
command.
ip
Quick Start up