Show Snmpcommunity - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Mode
Serial Port Login Timeout (minutes) Specifies the time, in minutes, of inactivity on a
Baud Rate
Character Size
Flow Control
Stop Bits
Parity Type

show snmpcommunity

This command displays SNMP community information.
Six communities are supported. You can add, change, or delete communities. The switch does not
have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP
specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external
SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community
parameters).
Format
Mode
SNMP Community Name The community string to which this entry grants access. A valid
Client IP Address -
Switching Commands
Privileged EXEC and User EXEC
Serial port connection, after which the Switch will close the con-
nection. Any numeric value between 0 and 160 is allowed, the
factory default is 5. A value of 0 disables the timeout.
The default baud rate at which the serial port will try to connect.
The available values are 1200, 2400, 4800, 9600, 19200,
38400,57600, and 115200 baud. The factory Default is 9600
baud.
The number of bits in a character. The number of bits is always 8.
Whether Hardware Flow-Control is enabled or disabled. Hard-
ware Flow Control is always disabled.
The number of Stop bits per character. The number of Stop bits is
always 1.
The Parity Method used on the Serial Port. The Parity Method is
always None.
show snmpcommunity
Privileged EXEC
entry is a case-sensitive alphanumeric string of up to 16 charac-
ters. Each row of this table must contain a unique community
name.
An IP address (or portion thereof) from which this device will
accept SNMP packets with the associated community. The
requesting entity's IP address is ANDed with the Subnet Mask
December 2004, 202-10010-02
8-25