User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Default
Format
Mode
remotecon maxsessions
This command specifies the maximum number of remote connection sessions that can be
established. A value of 0 indicates that no remote connection can be established. The range is 0 to
5.
Default
Format
Mode
no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to
the default value.
Default
Format
Mode
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default
Format
Mode
8-20
None
network protocol {none | bootp | dhcp},
indicates that the switch periodically sends requests to a Boot-
strap Protocol (BootP) server or a dhcp server until a response is
received.
indicates that the switch should be manually con-
none
figured with IP information.
Privileged EXEC
5
remotecon maxsessions <0-5>
Privileged EXEC
5
no remotecon maxsessions
Privileged EXEC
5
remotecon timeout <0-160>
Privileged EXEC
202-10009-01_060204
where
bootp
Switching Commands