Conventions - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
logical slot/port

Conventions

Network addresses are used to define a link to a remote host, workstation or network. Network
addresses are shown using the following syntax:
Table 5-1. Network Address Syntax
Address Type
ipaddr
macaddr
Double quotation marks such as "System Name with Spaces" set off user defined strings. If the
operator wishes to use spaces as part of a name parameter then it must be enclosed in double
quotation marks.
Empty strings ("") are not valid user defined strings.
Command completion finishes spelling the command when enough letters of a command are typed
to uniquely identify the command word. The command may be executed by typing <enter>
(command abbreviation) or the command word may be completed by typing the <tab> or <space
bar> (command completion).
The value 'Err' designates that the requested value was not internally accessible. This should never
happen and indicates that there is a case in the software that is not handled correctly.
The value of '-----' designates that the value is unknown.
Command Line Interface Structure
This parameter denotes a logical slot number and logical port
number assigned. This is applicable in the case of a port-channel
(LAG). The operator can use the logical slot number and the logi-
cal port number to configure the port-channel.
Format
A.B.C.D
YY:YY:YY:YY:YY:YY
December 2004, 202-10010-02
Range
0.0.0.0 to 255.255.255.255
(decimal)
hexidecimal digit pairs
5-3