Options Set Up Group - Honeywell UDC2800 Product Manual

Chapter 4 - Configuration

Options Set Up Group

Table 4-6: OPTION Group Function Prompts
Function
Prompt
Lower Display
Auxiliary
Output
67
Introduction
The Options group lets you configure the remote mode switch
(Digital Inputs) to a specific contact closure response or configure
the Auxiliary Output to be a specific selection with desired scaling.
Function Prompts
Selection or
Range of Parameter
Setting Definition
Upper Display
AUXILIARY OUTPUT SELECTION
This selection provides an mA output representing
one of several control parameters. The display for
auxiliary output viewing will be in engineering units
for all but output. Output will be displayed in
percent.
Disable NO AUXILIARY OUTPUT
PV PROCESS VARIABLE—Represents the percentage
of the process variable calculated with respect to
configured Auxiliary Output range (Auxiliary output
low scaling factor to Auxiliary output high scaling
factor).
Deviation DEVIATION (PROCESS VARIABLE MINUS
SETPOINT)—Represents Deviation percentage
calculated with respect to the configured Auxiliary
Output range (Auxiliary low scaling factor to
Auxiliary high scaling factor).
ATTENTION: Other prompts affected by
these selections: 4mA VAL and 20mA VAL.