Configuration
4.7
Options Set Up Group
Introduction
The Options group lets you configure the remote mode switch (Digital Inputs) to a
specific contact closure response, or configure the Auxiliary Output to be a specific
selection with desired scaling. Auxiliary Output and External Reset are mutually
exclusive.
Function Prompts
Prompt
Description
Auxiliary Output
AUXOUT
Auxiliary Output
0 PCT
Low Scaling Factor
100PCT
Auxiliary Output
High Scaling Factor
Digital Input
EXTRST
28
Table 4-6 OPTIONS Group Function Prompts
Selection or Range of Setting
This selection provides a current output
representing the process variable. The display for
auxiliary output viewing will be in engineering
units.
Other prompts affected by these selections: "0
PCT" and "100 PCT."
NONE
Disabled
PROC
Represents the value of the Process
Variable.
Value in Engineering Units
Value in Engineering Units
EXTERNAL RESET (DIGITAL INPUT) — resets
the latching relay on contact closure.
DIS – Disable
ENAB – Enable
UDC2300 Limit Controller Product Manual
Factory
Setting
DIS
0
100
DIS
1/01