Step
Operation
Mode
Restore Input Factory Calibration
Introduction
The factory calibration constants for all the input actuation types that
can be used with the controller are stored in its non-volatile memory.
Thus, you can quickly restore the "Factory Calibration" for a given
input actuation type by simply changing the actuation type to
another type and then changing it back to the original type.
Press
Result
Exit the calibration mode.
Lower
Display key
ATTENTION: A restored factory calibration overwrites any
previous field calibration done for the input and may change
the High and Low Range Limits.
Protect your field calibration from accidental overwrites by
configuring the appropriate Lockout selection after calibration.
See Configuration for more information.
Chapter 6 - Input Calibration
107