Honeywell UDC2800 Product Manual page 74

Function Selection or Range
Prompt of Setting
Lower Display Upper Display
SHED
Failsafe
PV Rate of Change
DI 1 Actuated
TC Warning
TC Failed
A1S1 Value Value in
engineering units
Parameter
Definition
ATTENTION: Alarm set-point range is
configurable from 0 to 9999.
Shed from Communications
Failsafe
PV Rate of Change
ATTENTION: Alarm set-point range is
configurable from 0 to 9999.
Digital Input 1 Actuated
Thermocouple Warning
ATTENTION: NOTE 1. Thermocouple
Warning means that the instrument has
detected that the Thermocouple Input is
starting to fail. Not valid for input types
other than Thermocouple.
Thermocouple Fail
ATTENTION: NOTE 2. Thermocouple
Failing means that the instrument has
detected that the Thermocouple Input is
in imminent danger of failing. Not valid
for input types other than
Thermocouple.
ALARM 1 SETPOINT 1 VALUE—This is the
value at which you want the alarm type chosen
in prompt A1S1 Type to actuate. The value
depends on what the setpoint has been
configured to represent. No setpoint is
required for alarms configured for
Communications SHED.
Chapter 4 - Configuration
74