6: Zone Setup - Honeywell Fire-Lite Alarms MS-9200UDLSE Manual

Programming
PROGRAMMING
1=WALKTEST
2=SYSTEM
3=ZONE SETUP
Maintenance Screen #2
126
3.7.6 Zone Setup
Pressing 3 while viewing Maintenance Screen #2 will display the following screen:
1=ENABLE
2=DISABLE
3=ZONE 97 98 99
Pressing 1 while viewing Zone Setup screen will display the following screen:
ZONE TO ENABLE
Z
A flashing cursor appears to the right of the Z. To enable a zone, enter the two digit
zone number (00 - 99). After the second digit is entered, the zone will be enabled and
the cursor will return to the original position. The next zone to be enabled can then be
entered. Press Esc (Escape) to return to the previous screen.
Pressing 2 while viewing Zone Setup screen will display the following screen:
ZONE TO DISABLE
Z
A flashing cursor appears to the right of the Z. To disable a zone, enter the two digit
zone number (00 - 99). After the second digit is entered, the zone will be disabled and
the cursor will return to the original position. The next zone to be disabled can then be
entered. Press Esc (Escape) to return to the previous screen.
Maintenance Programming Level
ZONE SETUP
Zone Setup Screen
Enable Screen
Disable Screen
MS-9200UDLS PN 52750:A 11/04/05