Honeywell Fire-Lite Alarms MS-9200UDLSE Manual page 70

Programming
EDIT CONTROL
1=ENABLED
2=TYPE
3=SILENCEABLE
Edit Control Screen #2
70
Type
To select the type of control module being programmed, press the 2 key while
viewing the Edit Control Screen #2. This will cause the control panel to display the
following Control Type Screens. Press the down arrow key to view additional
screens and selections.
CONTROL TYPE
1=BLANK
2=BELL-CIRCUIT
3=HORN-CIRCUIT
Control Type Screen #1
While viewing one of the Control Type screens, select the type of control module
being programmed by pressing the corresponding keypad number key. The display
will return to the Edit Control Screen #2 and indicate the new type selection.
Note: A control module set to the Resettable Power type will follow the main circuit
board 24 VDC resettable power unless the control module is disabled.
The following table contains control module type codes and their functions which
are displayed in the Control Type screens:
Control Type
Blank
Bell Circuit
Horn Circuit
Sounders
Relay
Strobe Circuit
Control
Resettable Power
HVAC SHUTDN
Note: For HVAC SHUTDN description, refer to "Control Module Operation" on
page 179
Master Programming Level
Special Function
None
None
None
None
Ignore Open Circuit
None
None
Relay Type - Ignore Open Circuit
Relay Type - Ignore Open Circuit
MS-9200UDLS PN 52750:A 11/04/05